Swisher Commercial Pro ATV Spreader

• Read Owner’s Manual before use and be sure to follow all safety label precautions provided on the Spreader Hopper.
• Always use ONLY CLEAN DRY MATERIAL and be sure the remove all unused material from
the Hopper after each use. Damp materials will cause material flow problems and material
freezing problems in cold temperatures.
• Be sure material is free of foreign matter such as packaging etc.
• Some materials may jam the Hopper Gate at lower settings so it may be necessary to use a larger setting and increase your mph to compensate for the increased material flow rate. Increasing your ground speed from 4 mph to 8 mph will decrease your application rate per acre by half if the same setting is used at both speeds.
• Light seed such as Kentucky Blue Grass can be mixed with a seed such as clover to aid in material flow at a 50/50 mix.
• Increased material density per acre can be achieved by adjusting the Motor Assembly closer to the Deflector and Hopper Gate. This accomplishes a narrower spread width, providing more lbs/sq-ft of material.
• Do not spread light seed in windy conditions as poor coverage will result.
• Proper material coverage is achieved with the greatest satisfaction by covering the desired area twice at half the recommended application rate indicated by the manufacturer of the material. Once by traveling length ways then by traveling cross ways to account for any underlap issues. The adjustment of the application rate can be made either by adjusting the Hopper Gate to a lesser setting or by increasing the ground speed of the application vehicle.
• When using the Spreader for salt/ice melts, fertilizer or other corrosive materials it is imperative that the Spreader is thoroughly cleaned to prevent corrosion causing premature failure of the product.

• Read Owner’s Manual before use and be sure to follow all safety label precautions provided on the Spreader Hopper.
• Always use ONLY CLEAN DRY MATERIAL and be sure the remove all unused material from
the Hopper after each use. Damp materials will cause material flow problems and material
freezing problems in cold temperatures.
• Be sure material is free of foreign matter such as packaging etc.
• Some materials may jam the Hopper Gate at lower settings so it may be necessary to use a... more

Corrosion wore right through main switch connection, all parts and other connections corroded, motor barely turns now when switch bypassed. Used for rock salt commercially.

Spreads salt but gets plugged up and doesn't spread accurately. Its either open or closed not much works in between. Hope they honor warranty not even 1 year yet. Not easy to mount will be a pain to remove in spring.