TerraGrip 20" x 8" Tractor Traction Belts

TerraGrip does exactly what it is meant to do. It does it with little or no damage to the turf. Works great for traction in snow also without damaging or leaving marks on your driveway or walkway surfaces. They are a little tricky to install, but follow the instructions carefully, and you won't need to throw a temper tantrum, or anything.

Not as bumpy a ride as I thought it would be. Fits tight even through turns. The real test is this winter if the traction is any better.

They are a must have for my Cub cadet. I like them over my chains because the don't scuff my garage floor.

I have a 2016 XT2 with a 3 stage snow blower. I put a weight kit on the rear of the lawn tractor but without these it still got stuck.

Easy to install and works as advertised. Very rough ride across cement/ hard surfaces, but now my mower wheels don't spin on hills and my mower is safer.

Last year we purchased a Craftsman hydro-static drive lawn mower...great machine but not good enough traction for our hilly and sometimes muddy lawn.

About a month ago we purchased a set of 20" x 8" traction belts for our mower. These greatly improve it's maneuverability. I can even make U-turns (not recommended by safety experts) when going down a slope without the uphill wheel spinning out most of the time. Acceleration spins that you are never quite sure if you are not pushing the speed control hard enough or have a wheel spinning are virtually eliminated.

The traction belts were a little difficult to install, but carefully following the instructions will get the job done....just keep tightening them until there are no loose belts. I didn't use the tire deflation method, but it will probably be OK if you don't get the belts too tight.

There were some reports in the reviews of tearing up the grass. I can make it do this, but reasonably normal acceleration poses no problem.

Durability remains to be seen, but after some pretty rough "testing" I see no evidence of failure.

All in all, this is a great product. both from a performance and a safety viewpoint.

Last year we purchased a Craftsman hydro-static drive lawn mower...great machine but not good enough traction for our hilly and sometimes muddy lawn.

About a month ago we purchased a set of 20" x 8" traction belts for our mower. These greatly improve it's maneuverability. I can even make U-turns (not recommended by safety experts) when going down a slope without the uphill wheel spinning out most of the time. Acceleration spins that you are never quite sure if you are not... more

They do give you traction but can rip up your lawn if you have a yard with hills

Smooth ride great traction.

A bit difficult to fix on a wheel, not really efficient on the icy surface. Would recommend to go with chains instead.

I have a hill in my backyard that I have been unable to ride my mower on and to level it contractors estimate over thousands to fix. Now I can go up and down with my cub cadet xt1 like butter, without a spin. Great product save me lots of money. I can even drive over driveway without leaving a mark. Easy five minutes to install recommend to anyone. My neighbors are now going out and buying mowers and ordering product.